Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 72 (KEYLESS START SYSTEM)DIAGNOSTICS INFORMATION AND PROCEDURESFAIL-SAFE TABLE
2013 Suzuki Kizashi Sport GTS, FWD
Fail-Safe Table
2013 Suzuki Kizashi Sport GTS, FWDSECTION Fail-Safe Table
WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
When DTC is detected, keyless start control module changes fail-safe mode as long as malfunction continues to exist but that mode is canceled when keyless start control module recovers normal condition.
FAIL-SAFE CHART
| DTC | DTC name | Fail-safe operation |
|---|---|---|
| B1120 | Keyless Start Control Module Internal Defect | - |
| B1122 | Backup Power Supply Malfunction | - |
| B1123 | Backup Power Supply Malfunction | - |
| B1125 | Clutch/Shift Switch Malfunction | Starting motor control relay is kept ON when engine switch is pressed continuously with ignition mode in "ON". |
| B1126 | P Position Switch Malfunction | Steering lock unit is kept unlocked. |
| B1134 | Remote Controller Battery Low | - |
| B1137 | Brake Light Switch Malfunction | Depending on the conditions, starting motor control relay is kept ON by either operation of the brake light switch signal or continuous pressing engine switch when ignition mode in "ON". |
| B1158 | LIN Communication Error | - |
| B1160 | Steering Lock Unit Communication Error | - |
| B1161 | Steering Lock Unit Information Mismatched | - |
| B1162 | Steering Lock Unit Internal Defect | - |
| B1163 | Steering Lock Unit Unregistered | - |
| B1170 | EEPROM Access Error | Keyless start control module controls with default value. |
| B1180 | Driver Side Door Request Switch Malfunction | Keyless start control module assumes that driver side door request switch signal is OFF. |
| B1181 | Passenger Side Door Request Switch Malfunction | Keyless start control module assumes that passenger side door request switch signal is OFF. |
| B1182 | Rear End Door/Trunk Lid Request Switch Malfunction | Keyless start control module assumes that trunk lid request switch signal is OFF. |
| B1190 | Engine Switch Malfunction |
|
| B1191 | Accessory Relay Malfunction | - |
| B1192 | Ignition1 Relay Malfunction | - |
| B1193 | Ignition2 Relay Malfunction | - |
| B1194 | Starting Motor Relay Malfunction | Starting motor control relay is kept ON when engine switch is pressed continuously. |
| B1901 | Internal Control Module Memory Check Sum Error | - |
| B1902 | Control Module Programming Error | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.