Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 56 (ELECTRONIC STABILITY PROGRAM)DIAGNOSTICS INFORMATION AND PROCEDURESDTC C1084: ESP® DETECTS MESSAGE COUNTER FAILURE FROM EPS/C1085: ESP® DETECTS CHECK SUM FAILURE FROM EPS/C1097: DTC CONCERNING POWER STEERING CONTROL MODULEDTC TROUBLESHOOTING
2013 Suzuki Kizashi Sport GTS, FWD
DTC Troubleshooting
2013 Suzuki Kizashi Sport GTS, FWDSECTION DTC Troubleshooting
WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTICS PROCEDURE CHART
| Step | Action | YES | NO |
|---|---|---|---|
| 1 | Was "ESP® System Check" performed? | Go to Step 2. | Go to ESP® SYSTEM CHECK . |
| 2 | DTC check
Is there DTC(s) other than C1084, C1085 or C1097? |
Go to APPLICABLE DTC TROUBLESHOOTING . | Go to Step 3. |
| 3 | DTC check for P/S system
Is there DTC(s) other than C1084, C1085 or C1097? |
Go to APPLICABLE DTC TROUBLESHOOTING . | Substitute a known-good P/S control module and recheck DTC, see P/S CONTROL MODULE REMOVAL AND INSTALLATION
. Substitute a known-good ESP® control module if DTC is still detected, see ESP® Hydraulic Unit/Control Module Assembly Removal and Installation . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.