Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 56 (ELECTRONIC STABILITY PROGRAM)DIAGNOSTICS INFORMATION AND PROCEDURESDTC CHECK
2013 Suzuki Kizashi Sport GTS, FWD
DTC Check
2013 Suzuki Kizashi Sport GTS, FWDSECTION DTC Check
WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
- Confirm that ignition mode of keyless push start system is in "OFF".
- Connect SUZUKI scan tool to DLC (1).
Special Tool
- SUZUKI scan tool (SUZUKI-SDT)
- Push engine switch to change ignition mode of keyless push start system to "ON".
- Read DTC according to instructions displayed on SUZUKI scan tool and prints it or write it down. Refer to SUZUKI scan tool operator's manual for further details . If communication between scan tool and ESP® control module is not possible, check that power supply and ground circuits of ESP® control module. If they are OK, go to TROUBLESHOOTING FOR COMMUNICATION BUS OFF .
- Confirm that ignition mode of keyless push start system is in "OFF" and disconnect SUZUKI scan tool from DLC after completing check.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.