SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLELECTRONIC STABILITY PROGRAMDIAGNOSTICS INFORMATION AND PROCEDURESESP® SYSTEM CHECKNOTES
2013 Suzuki Kizashi Sport GTS, FWD

ESP® System Check: Notes

2013 Suzuki Kizashi Sport GTS, FWDSECTION Notes

Refer to the following items for the details of each step.

DIAGNOSTICS PROCEDURE CHART

Step Action YES NO
1  Malfunction analysis 
  1. Perform CUSTOMER COMPLAINT ANALYSIS .
  2. Perform PROBLEM SYMPTOM CONFIRMATION .
  3. Perform DTC CHECK, RECORD AND CLEARANCE  and recheck DTC.

Is same DTC detected again after performing DTC clearance? 		 Go to Step 6. Go to Step 2.
2  Visual Inspection 
  1. Perform VISUAL INSPECTION .

Is there any faulty condition? 		 Repair or replace malfunction part, and go to Step 6. Go to Step 3.
3  Driving test 
  1. Perform STEP 3: DRIVING TEST .

Is malfunction detected? 		 Repair or replace malfunction part, and go to step 6. Go to Step 4.
4  Brakes diagnosis 
  1. Inspect and repair referring to BRAKE SYMPTOM DIAGNOSIS .

Is malfunction detected? 		 Repair or replace malfunction part, and go to step 6. Go to Step 5.
5  Intermittent problem check 
  1. Check for intermittent troubles referring to INTERMITTENT CONNECTION AND POOR CONTACT INSPECTION .

Is malfunction detected? 		 Repair or replace malfunction part, and go to step 6. Go to Step 6.
6  Final confirmation test 
  1. Perform STEP 6: FINAL CONFIRMATION TEST .

Does trouble recur? 		 Go to Step 4. End.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.