Console Replacement

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Console Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Console Components
G04844542Courtesy of SUZUKI OF AMERICA CORP.
CONSOLE COMPONENTS REFERENCE

Callout Component Name
Preliminary Procedure 
Remove the front seats. Refer to REMOVAL PROCEDURE .
1 Instrument Panel Lower Brace Bezel.
Refer to INSTRUMENT PANEL LOWER BRACE BEZEL REPLACEMENT .
2 Console Screws (Qty 2)
CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.

Tightening torque 
2 N.m (18 lb in) 
3 Console Bolt Covers (Qty 4)
Procedure 
Use a flat bladed plastic trim tool to remove the covers.
4 Console Bolts (Qty 6)
Tightening torque 
9 N.m (80 lb in) 
5 Console Assembly
Procedures 
  1. Pull the parking brake lever up to the fully engaged position.
  2. Disconnect the electrical connections to the console assembly.
  3. With the aid of an assistant remove the console from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.