SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2008SWIFT +REPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESFRONT DRIVE AXLEREPAIR INSTRUCTIONSWHEEL DRIVE SHAFT INNER JOINT AND BOOT REPLACEMENT (MANUAL)REMOVAL PROCEDURE
2008 Suzuki Swift +

Removal Procedure

2008 Suzuki Swift +SECTION Removal Procedure
    Fig 1: View Of Small And Large Boot Seals
    GM1242033Courtesy of GENERAL MOTORS CORP.
  1. Remove the large seal retaining clamp. Discard the clamp.
  2. Remove the small seal retaining clamp. Discard the clamp.
    3. Fig 2: View Of Shaft Retaining Ring With J 8059
    GM1242032Courtesy of GENERAL MOTORS CORP.
  3. Degrease the joint.
  4. Remove the shaft retaining ring using the J 8059  (1). See Special Tools .
    5. Fig 3: View Of Axle Shaft And Joint Assembly
    GM1242031Courtesy of GENERAL MOTORS CORP.
  5. Remove the axle shaft from the joint assembly.
    6. CAUTION: The ball retainer is stacked in position and is not servicable. Attempting to service the ball retainer could result in reduced vehicle performance and possible personal injury.
  6. Remove the seal from the joint assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.