Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2008SWIFT +REPAIR AND DIAGNOSISDRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESFRONT DRIVE AXLESPECIAL TOOLS AND EQUIPMENTSPECIAL TOOLS

2008 Suzuki Swift +

Special Tools

2008 Suzuki Swift +SECTION Special Tools

Illustration	Tool Number/ Description
Courtesy of GENERAL MOTORS CORP.	DT 47539 (DW 340-110) Axle Shaft Remover
Courtesy of GENERAL MOTORS CORP.	J-35566 Seal Clamp Pliers
Courtesy of GENERAL MOTORS CORP.	J-8059 Snap Ring Pliers
Courtesy of GENERAL MOTORS CORP.	KM-460-B Axle Shaft Remover
Courtesy of GENERAL MOTORS CORP.	KM-507-C Ball Joint Remover

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.