Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (ENGINE CONTROL SYSTEM (HEV) (DIAGNOSTICS) (GENERAL))
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Section 18 (Engine Control System (HEV) (Diagnostics) (General))
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Section 18 (Engine Control System (HEV) (Diagnostics) (General))
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnostics With Phenomenon
- General Scan Tool
- Operation
- How To Use General Scan Tool
- Mode $01 (Current Powertrain Diagnostic Data)
- Mode $02 (Powertrain Freeze Frame Data)
- Mode $03 (Emission-Related Powertrain DTC)
- Mode $04 (Clear/Reset Emission-Related Diagnostic Information)
- Mode $06 (Request On-Board Monitoring Test Results For Intermittently Monitored Systems)
- Mode $07 (Initial Emission-Related Powertrain DTC)
- Mode $08 (Request Control For On-Board System, Test, And Component)
- Mode $09 (Request Vehicle Information)
- Mode $0A (Emission-Related DTC (With Permanent Status))
- Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.