SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (CVT TRANSAXLE (TR580))TRANSMISSION CONTROL DEVICEREMOVAL
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

Transmission Control Device: Removal

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Removal
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the parking pawl. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580 CROSSTREK)>PARKING PAWL>REMOVAL .
  2. Remove the parking support.
    G13936145Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the inhibitor switch. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580 CROSSTREK)>INHIBITOR SWITCH>REMOVAL .
  4. Remove the oil pan and oil strainer. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580 CROSSTREK)>OIL PAN>REMOVAL .
  5. Remove the detent spring.
    G13936146Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the spring pin.
    NOTE:

    Be careful not to drop the spring pin in the transmission. 

    G13936147Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the shifter arm shaft.
    G13936148Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the manual valve rod (A) and remove the manual plate (B) and parking rod (C) as a unit.
    G13936149Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the parking rod from the manual plate.
  10. Remove the manual valve.
    G13936150Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the oil seal using a flat tip screwdriver wrapped with protection tape.
G13622215Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.