Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (CVT TRANSAXLE (TR580))ROAD TESTINSPECTIOND RANGE SHIFT FUNCTION
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
D Range Shift Function
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION D Range Shift Function
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the Subaru Select Monitor.CAUTION:
Make sure to route the Subaru Select Monitor wires so that they do not disturb the driving.
- Turn the ignition switch to ON. (Engine OFF)
- Display [Vehicle Speed] and [Actual Gear Ratio].
- Make sure that the engine speed is 1, 000 - 1, 400 r/min while driving on the level road at 50 km/h (31 MPH) after accelerating from halting up to 1/4 of accelerator opening angle.
- While the vehicle gradually decelerates from the condition in step 4 and finally stops, check that [Actual Gear Ratio] changes smoothly according to [Vehicle Speed].
CAUTION:
Make sure to get an assistant on the vehicle and have the person read the data.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.