Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (CVT TRANSAXLE (TR580))AT LEARNINGPROCEDUREPREPARATION FOR LEARNING
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Preparation For Learning
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Preparation For Learning
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the Subaru Select Monitor.
- Turn the ignition switch to ON. (Engine OFF)
- Display [ATF Temp.].
- Warm up or cool down until [ATF Temp.] displayed on the Subaru Select Monitor is 40 - 65°C (104 - 149°F).
- After stopping the vehicle, shift the select lever to "P range".
- Apply the parking brake.
- Turn the ignition switch to OFF.
- Lift up the vehicle.CAUTION:
- Lift up the vehicle until the tire bottom is 0.3 m (0.98 ft) or more above the ground.
- Make sure that safety is secured where the tiers rotate.
- Turn the ignition switch to ON. (Engine OFF)
- Turn off all systems causing an electrical load, such as headlights, A/C, seat heater and rear defogger, etc.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.