Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENTATION SYSTEM (DIAGNOSTICS)ACTIVE TESTLISTEXCEPT FOR HYBRID MODEL
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Except For Hybrid Model
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Except For Hybrid Model
| Check meter & gauge operation | Speedometer | 0 km/h(MPH) |
| 40 km/h(MPH) | ||
| 80 km/h(MPH) | ||
| 120 km/h(MPH) | ||
| 160 km/h(MPH) | ||
| 200 km/h(MPH) | ||
| 240 km/h(MPH) | ||
| 280 km/h(MPH) | ||
| Back | ||
| Tacho meter | 0 rpm | |
| 1000 rpm | ||
| 2000 rpm | ||
| 3000 rpm | ||
| 4000 rpm | ||
| 5000 rpm | ||
| 6000 rpm | ||
| 7000 rpm | ||
| Back | ||
| Fuel gauge | Fuel sender F-point command | |
| F dial | ||
| Meter 3/4 scale command | ||
| Meter 1/2 scale command | ||
| 1/4 dial | ||
| Low fuel warning indicate point | ||
| E dial | ||
| Fuel sender E-point command | ||
| Back | ||
| Eco gauge | + side MAX | |
| + side middle | ||
| 0 | ||
| - side middle | ||
| - side MAX | ||
| Back | ||
| Back | ||
| Check display operation | Color check | White indication |
| Black indication | ||
| Red indication | ||
| Green indication | ||
| Blue indication | ||
| Gradation indication | ||
| Flicker indication | ||
| Cross talking indication | ||
| Back | ||
| Odometer | Display "9" | |
| Display "8" | ||
| Display "7" | ||
| Display "6" | ||
| Display "5" | ||
| Display "4" | ||
| Display "3" | ||
| Display "2" | ||
| Display "1" | ||
| Display "0" | ||
| Back | ||
| Shift Display | Display "P" | |
| Display "R" | ||
| Display "N" | ||
| Display "D" | ||
| Display "L" | ||
| Display "8" | ||
| Display "7" | ||
| Display "6" | ||
| Display "5" | ||
| Display "4" | ||
| Display "3" | ||
| Display "2" | ||
| Display "1" | ||
| Shift up | ||
| Shift down | ||
| Back | ||
| Back | ||
| Check light operation | All lamps lighted | |
| High | ||
| Front fog light | ||
| Position light | ||
| HID auto leveler | ||
| LED LO beam | ||
| SRH OFF | ||
| High Beam Assist Active Indicator | ||
| HBA OFF/FAIL | ||
| Turn Right | ||
| Turn Left | ||
| BRAKE | ||
| ABS | ||
| VDC operation/failure | ||
| VDC OFF | ||
| Hill start assist OFF/failure | ||
| Hill descent assist | ||
| Vacuum pump failure | ||
| EPS | ||
| Check E/G | ||
| Oil pressure | ||
| Charge | ||
| E/G remaining oil | ||
| Water temperature (HOT) | ||
| Water temperature (COOL) | ||
| Idling Stop | ||
| Auto start stop system OFF/failure | ||
| AWD | ||
| AT (CVT) oil temperature | ||
| EyeSight failure | ||
| LANE OFF | ||
| P-CR OFF | ||
| All seats door | ||
| Driver side door | ||
| Passenger side door | ||
| Rear side (right) door | ||
| Rear side (left) door | ||
| Reargate open | ||
| Trunk open | ||
| No-key warning | ||
| Driver side seat belt | ||
| Airbag | ||
| TPMS | ||
| Remaining washer fluid | ||
| Remaining fuel | ||
| Dual-range LO indicator | ||
| SRVD | ||
| SRVD OFF | ||
| CRUISE indicator | ||
| SET indicator | ||
| [S] indicator | ||
| [I] indicator | ||
| [X] indicator | ||
| Back | ||
| Check illumination operation | Brightness check | |
| Check buzzer operation | ||
| Check external ECM output operation | Warning Lamp Box | |
| Shift indicator | ||
| Back |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.