Trunk Lid Opener

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Trunk Lid Opener
  1. Before installation, check the following items.
    • Cable is free from deformation such as fray.
  2. Install the cable assembly - trunk lid and the cable assembly - fuel.
  3. Install the lower inner trim. Ref. to EXTERIOR/INTERIOR TRIM>LOWER INNER TRIM>INSTALLATION .
  4. Install the trim panel - trunk side RH and the trim panel - trunk lid. Ref. to EXTERIOR/INTERIOR TRIM>TRUNK ROOM TRIM>INSTALLATION .
  5. Install the spacer - rear floor front.
  6. Install the trim panel - trunk mat and the spacer - CTR.
  7. Install the pull handle - opener.

    Tightening torque:Β 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  8. Install the cover - handle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.