Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEM - SECURITY AND LOCKSREMOTE OPENERSINSPECTIONUNIT INSPECTIONFUEL FLAP STATUS SWITCH
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Fuel Flap Status Switch
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Fuel Flap Status Switch
- Check fuel flap status switch
Measure the resistance between connector terminals.
Preparation tool:Β
Circuit tester
Terminal No. Inspection conditions Standard 1 - 2 When the switch is not pressed Less than 1 Ξ© When the switch is pressed 1 MΞ© or more - Replace the saucer - COMPL if faulty is found in the inspection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.