Front Door

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Front Door
  1. Raise the glass assembly - front door to the top position.
  2. Remove the cover - handle front outer.
    1. Remove the plug at the rear end of the panel assembly - front door.
      G11246295Courtesy of SUBARU OF AMERICA, INC.
    2. Loosen the TORX® bolt and remove the cover - handle front outer.

      Preparation tool: 

      TORX® T30

    G11246296Courtesy of SUBARU OF AMERICA, INC.
  3. Replace the key cylinder.
    1. Release the claws.
    2. Remove the key cylinder (b) from the cover - handle front outer (a), and replace the key cylinder.
      G11246363Courtesy of SUBARU OF AMERICA, INC.
  4. Install the cover - handle front outer.
    CAUTION:
    • When installing the cover - handle front outer on driver's side, make sure that the key cylinder shaft is correctly inserted into the latch & actuator assembly - front. 
    • After installation, perform the operation check using the key. 

    Preparation tool: 

    TORX® T30

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.