Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEM - SECURITY AND LOCKSGENERAL DESCRIPTIONCAUTION
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Anti-Theft System - Security And Locks: General Description: Caution
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Caution
- When performing service operation, refer to "Repair Contents" in "General Description". Ref. to REPAIR CONTENTS>REPAIR CONTENTS .
- Before disconnecting connectors of sensors or units, be sure to disconnect the ground terminal from the battery sensor. (Except for hybrid model)
- Before disconnecting connectors of sensors or units, be sure to disconnect the ground terminal from battery. (Hybrid model)
- If any immobilizer related part has been replaced, make sure to register the immobilizer.
- Be careful of the following items. Failing to do so may cause the airbag system malfunction.
- Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.
- When removing, installing or replacing the VDCCM & H/U, VDCCM & H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform "VSC(VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.