Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEM - SECURITY AND LOCKSFUNCTION SETTING (CUSTOMIZE)PROCEDURESTOPPING KEYLESS ACCESS SYSTEM FUNCTION BY DOOR OPEN/CLOSE PROCEDURE
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Stopping Keyless Access System Function By Door Open/Close Procedure
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Stopping Keyless Access System Function By Door Open/Close Procedure
- Check that the vehicle status is as follows:
- Ignition switch OFF
- One window is completely open
- Keyless access system is activated (or disabled if re-activating)
- Sit in the driver's seat with the door closed and press the door lock switch to UNLOCK once.
- Open the driver's door within five seconds.
- Within 5 seconds, with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
- Within 10 seconds after finishing step 4), perform the closing → opening operation of the driver's door twice.
- Within 10 seconds after finishing step 5), with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
- Within 10 seconds after finishing step 6), perform the closing → opening operation of the driver's door once.
- Within five seconds after finishing step 7), close the drivers door.
- The buzzer sounds for two seconds, and the function stops.NOTE:
- Perform the same procedures to re-activate the keyless access system from the disabled condition.
- In step 4) and step 6), press the door lock switch completely. The function may not work properly if the switch is pressed shortly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.