Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (CONTINUOUSLY VARIABLE TRANSAXLE (CVT) (H6DO))INTERMEDIATE CASEASSEMBLY
2016 Subaru Legacy 2.5i
Intermediate Case: Assembly
2016 Subaru Legacy 2.5iSECTION Assembly
WARNING: This page is about a different variant/trim than selected.
- Install the reverse brake. < Ref. to ASSEMBLY , Reverse Brake Assembly. >
- Install all plugs to intermediate case.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
NOTE: Use new O-rings.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.