Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEM - SECURITY AND LOCKSFRONT HOOD LOCK ASSEMBLYINSTALLATION

2016 Subaru Legacy 2.5i

Front Hood Lock Assembly: Installation

2016 Subaru Legacy 2.5iSECTION Installation

CAUTION:

Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a).

Fig 1: Caution For Installing Front Bumper Face
Courtesy of SUBARU OF AMERICA, INC.
Before installing the bumper face, match the claws on the bracket - front bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, the flange section may be broken or the clearance between fender panel and bumper face may not be uniform.

Before installation, check the following items.
- Is the cable deformed?
- Grease is applied sufficiently to cable joints.
If grease is insufficient, add it as necessary before assembling the cable.
Adjust and install the lock assembly - front hood.
NOTE: Refer to "ADJUSTMENT" for adjustment of the lock assembly - front hood. < Ref. to ADJUSTMENT , Front Hood Lock Assembly. >

Tightening torque:

33 N.m (3.4 kgf-m, 24.3 ft-lb)
Install the radiator upper brackets.
Tightening torque:

12 N.m (1.2 kgf-m, 8.9 ft-lb)
Attach the bracket - grille.
Install the bumper face - front. < Ref. to INSTALLATION , Front Bumper. >
Install the air intake duct. < Ref. to INSTALLATION , Air Intake Duct. >

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.