SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSCONTINUOUSLY VARIABLE TRANSAXLE (CVT)CONVERTER CASEINSTALLATION
2014 Subaru Legacy 2.5i, Automatic CVT Trans

Converter Case: Installation

2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Installation
  1. Install the oil pump. Refer to INSTALLATION .
  2. Install the oil pump chain cover. Refer to INSTALLATION .
  3. Install the front differential assembly. Refer to INSTALLATION .
  4. Install the drive pinion shaft assembly. Refer to INSTALLATION .
  5. Install the forward clutch assembly. Refer to INSTALLATION .
  6. Install the reverse brake assembly. Refer to INSTALLATION .
  7. Install the primary pulley, secondary pulley and variator chain. Refer to INSTALLATION .
  8. Install the reduction drive gear. Refer to INSTALLATION .
  9. Install the transmission case. Refer to INSTALLATION .
  10. Install the transmission control device. Refer to INSTALLATION .
  11. Install the oil strainer and oil pan. Refer to INSTALLATION .
  12. Install the reduction driven gear assembly. Refer to INSTALLATION .
  13. Install the transfer driven gear assembly. Refer to INSTALLATION .
  14. Install the transfer clutch assembly. Refer to INSTALLATION .
  15. Install the parking pawl. Refer to INSTALLATION .
  16. Install the extension case. Refer to INSTALLATION .
  17. Install the inhibitor switch. Refer to INSTALLATION .
  18. Install the secondary speed sensor. Refer to INSTALLATION .
  19. Install the primary speed sensor. Refer to INSTALLATION .
  20. Install the turbine speed sensor. Refer to INSTALLATION .
  21. Install the transmission harness. Refer to INSTALLATION .
  22. Install the control valve body. Refer to INSTALLATION .
  23. Install the air breather hose. Refer to INSTALLATION .
  24. Install the transmission assembly to the vehicle. Refer to INSTALLATION .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.