Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSEATSSEAT SYSTEM - SEATSPOWER SEAT SYSTEMREMOVALLUMBAR SWITCH

2014 Subaru Legacy 2.5i, Automatic CVT Trans

Lumbar Switch

2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Lumbar Switch

Remove the seat from vehicle. < Ref. to REMOVAL , Front Seat. >
Remove the seat side cover OUT.
1. Release the claw in the rear section of the seat side cover.
2. Release the claw in the upper section of the seat side cover.
3. Remove the clip and release the claw in the front section of the seat side cover
4. Disconnect the power seat switch and lumber switch connectors and remove the seat side cover OUT.
  
  Fig 1: Removing Seat Side Cover (OUT)
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector and remove the lumbar switch assembly.

Fig 2: Identifying Lumbar Switch Assembly Connector
Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.