SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 6 (AUTOMATIC TRANSMISSION CVT (TR580) - SERVICE INFORMATION)CONVERTER CASEINSTALLATION
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans

Converter Case: Installation

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Installation
WARNING: This page is about a different variant/trim than selected.
  1. Install the oil pump. < Ref. to INSTALLATION , Oil Pump. >
  2. Install the oil pump chain cover. < Ref. to INSTALLATION , Oil Pump Chain. >
  3. Install the front differential assembly. < Ref. to INSTALLATION , Front Differential Assembly. >
  4. Install the drive pinion shaft assembly. < Ref. to INSTALLATION , Drive Pinion Shaft Assembly. >
  5. Install the forward clutch assembly. < Ref. to INSTALLATION , Forward Clutch Assembly. >
  6. Install the reverse brake assembly. < Ref. to INSTALLATION , Reverse Brake Assembly. >
  7. Install the primary pulley, secondary pulley and variator chain. < Ref. to INSTALLATION , Primary Pulley and Secondary Pulley. >
  8. Install the reduction drive gear. < Ref. to INSTALLATION , Reduction Drive Gear. >
  9. Install the transmission case. < Ref. to INSTALLATION , Transmission Case. >
  10. Install the transmission control device. < Ref. to INSTALLATION , Transmission Control Device. >
  11. Install the oil strainer and oil pan. < Ref. to INSTALLATION , Oil Pan and Strainer. >
  12. Install the reduction driven gear assembly. < Ref. to INSTALLATION , Reduction Driven Gear. >
  13. Install the transfer driven gear assembly. < Ref. to INSTALLATION , Transfer Driven Gear. >
  14. Install the transfer clutch assembly. < Ref. to INSTALLATION , Transfer Clutch. >
  15. Install the parking pawl. < Ref. to INSTALLATION , Parking Pawl. >
  16. Install the extension case. < Ref. to INSTALLATION , Extension Case. >
  17. Install the inhibitor switch. < Ref. to INSTALLATION , Inhibitor Switch. >
  18. Install the secondary speed sensor. < Ref. to INSTALLATION , Secondary Speed Sensor. >
  19. Install the primary speed sensor. < Ref. to INSTALLATION , Primary Speed Sensor. >
  20. Install the turbine speed sensor. < Ref. to INSTALLATION , Turbine Speed Sensor. >
  21. Install the transmission harness. < Ref. to INSTALLATION , Transmission Harness. >
  22. Install the control valve body. < Ref. to INSTALLATION , Control Valve Body. >
  23. Install the air breather hose. < Ref. to INSTALLATION , Air Breather Hose. >
  24. Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.