Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Camera Initialization
This is a recovery measures prepared for the data failure caused by the low battery voltage during data storage to inside the stereo camera.
Perform the camera initialization only when the aiming result is NG even if the vehicle is placed correctly in the flowchart described in "A: Procedure".
- Turn the ignition switch to ON.
- Wait for 10 seconds.
- On Main Menu display, select {Each System Check}.
- On «System Selection Menu», select {ADA adaptive cruise control system}.
- Select «EyeSight (from 2009MY)».
- Select {Clear Memory} while pressing the camera cover mounted pre-collision brake OFF switch and lane departure warning OFF switch at the same time.
- Turn the ignition switch to OFF.
- Wait for 5 seconds.
- Next, perform the clear adjustment value. < Ref. to ADJUSTMENT VALUE CLEAR , PROCEDURE, Camera Adjustment, Inspection. >
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.