DTC C0045 TCM Malfunction: Trouble Symptom

2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Trouble Symptom
  • ABS does not operate.
  • VDC does not operate.
DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK AT SYSTEM.Β 
  1. Start the engine.
  2. Check the DTC in AT system.
Is DTC of AT system displayed? Repair the AT system. Go to step 2.Β 
2 CHECK THE VDCCM&H/U.Β 
  1. Connect all connectors.
  2. Erase the memory.
  3. Perform the Inspection Mode.
  4. Read the DTC.
Is the same DTC displayed? Replace the VDCCM only. Go to step 3.Β 
3 CHECK OTHER DTC DETECTION.Β  Is any other DTC displayed? Perform the diagnosis according to DTC. It results from a temporary noise interference.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.