Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2005OUTBACK I, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSREAR DOOR LATCH & DOOR LOCK ACTUATOR ASSEMBLYREMOVAL
2005 Subaru Outback i, Standard
Rear Door Latch & Door Lock Actuator Assembly: Removal
2005 Subaru Outback i, StandardSECTION Removal
- Disconnect the ground cable from battery.
- Remove the rear door trim. < Ref. to REMOVAL , Door Trim. >
- Remove the cable from rear inner remote. < Ref. to , REMOVAL , Rear Inner Remote. >
- Remove the sealing cover.
- Remove the rear door glass. < Ref. to REMOVAL , Rear Door Glass. >
- Remove the rear sash. < Ref. to REMOVAL , Rear Regulator and Motor Assembly. >
- Take out the cable from cable clamp of outer handle.
- Remove the three screws.
- Disconnect the connectors, and then remove the rear door latch & door lock actuator assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.