Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2005OUTBACK I, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSREAR REGULATOR AND MOTOR ASSEMBLYREMOVAL

2005 Subaru Outback i, Standard

Rear Regulator and Motor Assembly: Removal

2005 Subaru Outback i, StandardSECTION Removal

Remove the rear door glass. < Ref. to REMOVAL , Rear Door Glass. >
Remove the nut (A) to remove front sash.

Fig 1: Removing Nut
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the motor connector.
Remove the four bolts and two nuts to remove regulator assembly.

Fig 2: Removing Four Bolts And Two Nuts
Courtesy of SUBARU OF AMERICA, INC.
Remove the screws to remove motor assembly.

Fig 3: Removing Screws To Remove Motor Assembly
Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.