SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSCION2008XD AUTOMATICREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKES - ABSFRONT SPEED SENSORINSTALLATION
2008 Scion xD Automatic

Front Speed Sensor: Installation

2008 Scion xD AutomaticSECTION Installation
  1. INSTALL FRONT SPEED SENSOR 
    Fig 1: Locating Clamp A From Body
    G05401288Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the speed sensor onto the steering knuckle with the bolt.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

      NOTE:
      • Check that the speed sensor tip and installation portion are free of foreign matter.
      • Install the speed sensor without turning it from its original installation angle.
    2. Install the No. 1 sensor clamp onto the shock absorber with the bolt.

      Torque: 29 N*m (300 kgf*cm, 22 ft.*lbf) 

    3. Install the No. 2 sensor clamp onto the body with the bolt.

      Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

    4. Engage the clamps D, C and B onto the body.
    5. Connect the speed sensor connector.
    6. Engage the clamp A onto the body.
  2. INSTALL FRONT FENDER LINER  (See INSTALLATION )
  3. INSTALL SIDE MUDGUARD  (See INSTALLATION )
  4. INSTALL ROCKER PANEL MOLDING COVER  (See INSTALLATION )
  5. INSTALL FRONT WHEEL 

    Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

  6. CHECK ABS SENSOR SIGNAL (w/o VSC) 

    (See TEST MODE PROCEDURE  )

  7. CHECK VSC SENSOR SIGNAL (w/ VSC) 

    (See TEST MODE PROCEDURE  )

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.