Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Programming Cancellation
2000 Saturn SC2 Automatic, MP6SECTION Programming Cancellation
WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Programming sequence will cancel if one of the following conditions occur:
- Program Mode Is Exited Through DIC
- Ignition Is Turned Off
- All 4 TPM Sensors Have Been Programmed
- TPM system Has Been In Program Mode For More Than 2 Minutes & No Sensors Have Been Programmed
If program mode is cancelled with less than 4 TPM sensors stored, remote control door lock receiver will only accept codes programmed up to that point.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.