Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Air Bag (Inflator) Module: Removal
Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS . Disable SIR system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Remove and discard 4 air bag module screws behind steering wheel. Pull up air bag module, and then disconnect electrical connectors from module. Remove module. Installation
Connect electrical connectors to module. Install module using 4 new mounting screws. Tighten screws to 106 INCH lbs. (12 N.m). Activate SIR system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.