Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1992SC STANDARDREPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNDISABLING & ACTIVATING AIR BAG SYSTEM
1992 Saturn SC Standard
Disabling & Activating Air Bag System
1992 Saturn SC StandardSECTION Disabling & Activating Air Bag System
CAUTION:
When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES
article in the GENERAL INFORMATION section before disconnecting battery.
- Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS . To disable air bag, turn ignition off. Disconnect and shield negative battery cable. Remove SIR fuse from fuse block. Remove Connector Position Assurance (CPA) clip from Yellow SIR connector at base of steering column. (All SIR system connectors use CPA clips to ensure connector retention.) Disconnect Yellow connector. Wait 15 minutes before working on vehicle.
- To activate air bag system, turn ignition switch off. Connect Yellow SIR connector and CPA clip at base of steering column. Install SIR fuse. Connect negative battery cable. Turn ignition switch to RUN position. Observe AIR BAG indicator light. Light should flash 7-9 times, and then go out. If AIR BAG indicator light does not function as described, a malfunction in air bag system exists.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.