Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
Basic Engine
- Adjustment - Replacement
- Powertrain
- Engine Mounting And Engine Pad, RH
- Front Torque Arm
- Engine Mounting, Left
- Engine Mounting Rear
- Engine Block
- Replacement Of Balancer-Shaft Bearings
- Cylinder Head
- Pistons, Connecting Rod, Cylinder Bores
- Valve Gear
- Valve-Gear Timing
- Valve Gear (In Car)
- Valve Seats
- Checking Valve Tightness
- Hydraulic Tappets
- Checking Valve Clearances
- Changing Balancer Shaft Chain
- Changing Balancer Shaft Chain/Timing Chain In Car
- Chain TENSIONER, Timing Chain
- Replacement Of Timing Chain (In Car)
- Timing Cover
- Crankshaft, Clearance
- Changing The Crankshaft Seal (In Car)
- Drive Belt For Auxiliaries
- Oil Pump (In Situ)
- Oil Sump (In Car)
- Oil Sump (In Car) B235R Manual
- Oil Filter Adapter Housing
- Engine Oil Thermostat
- Reducing Valve
- Measuring Oil Pressure
- Pitting In The Cylinder Block
- Special Tools
- 30 05 469 Adapter, Cooling System Tester
- 30 05 758 Fluid Tester
- 30 06 558 PLASTIGAGE
- 75 19 531 Protective Collar (Type 10)
- 78 40 622 Dial Gauge
- 78 60 802 Oil Pan
- 78 61 040 Valve Seat Cutter, 11° And 45° (34.5 Mm)
- 78 61 065 T-Wrench
- 78 62 287 Piston Fitting Tool
- 78 74 878 Floor Stand
- 82 93 094 Sleeve 27 Mm
- 82 93 128 Template 1/2"
- 83 90 130 Spring Balance
- 83 90 270 Sliding Hammer
- 83 90 478 Axle
- 83 90 858 Journal
- 83 91 401 Magnetic Tool
- 83 92 409 Lifting Sling
- 83 93 332 Wrench, Small Oil Filter
- 83 93 472 Wrench, Knock Sensor And Oil Pressure Switch
- 83 93 746 Protective Collar
- 83 93 753 Measuring Bridge, Valve Position
- 83 93 761 Valve Spring Tool
- 83 93 779 Tappets
- 83 93 787 Valve Stand
- 83 93 936 Valve Seat Cutters, 60°
- 83 93 985 Belt-Tension Meter
- 83 94 157 Pliers, Valve Guide Seal
- 83 94 173 Compressed Air Adapter For Spark Plug Hole
- 83 94 181 Removal Tool
- 83 94 207 Fitting Tool
- 83 94 470 Balancer Shaft Bearing Press
- 83 94 520 Wrench, Lock Nut
- 83 94 637 Removal Tool
- 83 94 645 Fitting Tool
- 83 94 652 Fixture
- 83 94 660 Chain Lock
- 83 94 678 Timing Chain Removal Kit, 16 Valve
- 83 94 744 Adapter, Fuel Pressure Testing
- 83 94 850 Lifting Beam
- 83 94 868 Flywheel Locking Attachment
- 83 94 876 Fitting Tool, Crankshaft Seal
- 83 94 884 Fitting Tool, Crankshaft Seal
- 83 95 071 Fitting Tool, Valve Stem Gasket
- 83 95 147 Adapter
- 83 95 170 Intermediate Piece
- 83 95 196 Holder, Front
- 83 95 204 Steering Swivel, 5 Mm
- 83 95 212 Strap
- 83 95 220 Engine Holder, 4-CYL.
- 83 95 238 Wedge
- 83 95 246 Valve Spring Depressor
- 83 95 254 Drawbar Handle, Hydraulic Belt TENSIONER
- 83 95 287 Holder
- 83 95 311 Trolley Lift
- 83 95 345 Adapter, Compression Pressure Sensor
- 83 95 485 Spark Plug Socket Assembly With Locating Sleeves
- 83 95 501 Air Nipple
- 83 95 527 Guide And Plastic Screw
- 83 95 535 Hook With Wing Nut
- 85 80 144 Puller Windscreen Wiper Arm
- 86 12 509 Floor Stand Base
- 87 90 727 Bracket, Dial Gauge
- 87 91 857 Contact Points
- 87 92 194 Dial Gauge Kit
- 87 92 335 Locking Pin
- 87 92 442 Lifting Cable
- 87 92 574 Holder
- 87 92 665 Protective Plug, Drive Shaft Hole
- 89 96 696 Puller
- 83 96 277 Centering Drift Clutch Disc, 6-Speed Transmission
- Technical Data
- Technical Description
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.