Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Block: Pistons
The pistons are made of light alloy and have grooves for two compression rings and one oil scraper ring.
The upper compression ring is flat and chrome or molybdenum plated. The lower compression ring acts as an oil scraper, is somewhat wider than the upper compression ring and has three sections. The pistons are internally reinforced and designed for trapezoid connecting rods. The pistons are tin plated and their upper parts hard anodized. The gudgeon pins are nitro-hardened. The compression ratio of the B205 is 8.8:1 and of the B235 9.3:1.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
