Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
General data
GENERAL DATA CHART
| Diameter of balancer-shaft journal (inner) | mm | 39.892-39.908 |
| Diameter of balancer-shaft bearing (inner) | mm | 39.988-40.043 |
| Bearing clearance, journal bearing (inner) | mm | 0.080-0.151 |
| Maximum permissible bearing clearance (inner) | mm | 0.18 |
| Diameter of balancer-shaft journal (outer) | mm | 19.947-19.960 |
| Diameter of balancer-shaft bearing (outer) | mm | 20.000-20.021 |
| Bearing clearance, journal bearing (outer) | mm | 0.040-0.074 |
| End float | mm | 0.060-0.460 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.