Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB1995900 S, 2D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSAIR BAG, SRSAIR BAG RESTRAINT SYSTEM
1995 Saab 900 S, 2D Hatchback, Automatic
Air Bag Restraint System
1995 Saab 900 S, 2D Hatchback, AutomaticSECTION Air Bag Restraint System
- Description & Operation
- System Operation Check
- Post-Collision Inspection
- Service Precautions
- Adjustments
- Disabling & Activating Air Bag System
- Disposal Procedures
- Removal & Installation
- Diagnosis & Testing
- Notes
- Self-Diagnostic System
- DTC B1227 - Short To Voltage
- DTC B1228 - Open Circuit Or Short Circuit To Ground
- DTC B1332 - Break In Wiring
- DTC B1333 - Short Between Air Bag Harness Leads
- DTC B1337 - Break In Wiring
- DTC B1338 - Short Between Air Bag Harness Leads
- DTC B1605 - Control Module Internal Fault
- DTC B1610 - Control Module Programming Error
- DTC B1615 - Air Bag Ignition Circuit Activated
- DTC B2332/B2337 - Air Bag Wiring Short Circuit To Ground
- DTC B2333/B2338 - Air Bag Short Circuit To Voltage
- DTC B2441 - Break In Wiring
- DTC B2442/B2447 - Belt TENSIONER Short Circuit To Ground
- DTC B2443/B2448 - Belt TENSIONER Short Circuit To Voltage
- B2444 - Short Between Driver-Side Belt TENSIONER Harness Leads
- DTC B2446 - Break In Wiring
- DTC B2449 - Short Between Passenger-Side Belt TENSIONER Leads
- No Trouble Codes Are Present - No Voltage Feed
- Before Replacing Control Module
- Wire Repair
- Torque Specifications
- Wiring Diagram
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.