Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (ENGINE CONTROL SYSTEM - 2.4L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSFUEL TANK DRAINING PROCEDUREDRAINING PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard
Draining Procedure
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Draining Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the fuel fill cap.
- Install the J 42960-2 into the fuel fill pipe in order to hold the door open. See Special Tools .
- Insert the J 45004 into the fuel tank until the hose reaches the bottom of the fuel tank. See Special Tools .
- Use a hand or air operated pump device in order to drain as much fuel through the fuel fill pipe as possible.
IMPORTANT:
Lubricate the fuel drain hose with J 36850
or equivalent to aid in hose insertion. See Special Tools . Do not use an unapproved lubricant.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.