Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (ENGINE CONTROL SYSTEM - 2.4L - INTRODUCTION (2 OF 2))SPECIAL TOOLS AND EQUIPMENTSPECIAL TOOLS
2006 Pontiac G6 GTP, 2D Coupe, Standard
Special Tools
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Special Tools
WARNING: This page is about a different variant/trim than selected.
Special Tools
| Illustration | Tool Number/Description |
|---|---|
| GE-41415-50 Interrupted Thread Fuel Tank Cap Adapter |
|
| GE-41415-50 Fuel Tank Cap Adapter |
|
| J 26792 HEI Spark Tester |
|
| J 34730-1A Fuel Pressure Gage |
|
| J 36012-A Ignition System Diagnosis Harness |
|
| J 36850 Transjel Lubricant |
|
| J 37088-A Fuel Line Disconnect Tool Set |
|
| J 37287 Fuel Line Shut-Off Adapters |
|
| J 38522 Variable Signal Generator |
|
| J 39021 Fuel Injector Coil and Balance Tester |
|
| J 41413 EVAP Pressure and Purge Station |
|
| J 41413-200 Evaporative Emissions System Tester (EEST) |
|
| J 41413-SPT High Intensity White Light |
|
| J 42960-2 Fuel Flapper Door Holder |
|
| J 43244 Relay Puller Pliers |
|
| J 44175 Fuel Composition Tester |
|
| J 44602 Injector Test Adapter |
|
| J 44603 Injector Test Lamp |
|
| J 45004 Fuel Tank Drain Hose |
|
| J 45722 Fuel Sender Lock Ring Wrench |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.