SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 187 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING GEAR REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the outer tie rod ends to the steering gear. Refer to Rack and Pinion Outer Tie Rod End Replacement .
    2. Fig 1: Removing Steering Gear To Frame Bolts
    GM1229955Courtesy of GENERAL MOTORS CORP.
  2. Install the steering gear to the vehicle. Rotate the gear as necessary to clear the rear transmission mount.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the steering gear to frame bolts.

    Tighten:  Tighten the bolts to 70 N.m (52 lb ft) plus an additional 90 degrees.

    4. Fig 2: View Of Intermediate Shaft-To-Steering Gear Pinch Bolt
    GM851655Courtesy of GENERAL MOTORS CORP.
  4. Connect the intermediate steering shaft to the steering gear as noted during removal.
  5. Install the new intermediate steering shaft to steering gear pinch bolt.

    Tighten:  Tighten the bolt to 49 N.m (36 lb ft).

  6. Connect the outer tie rod ends to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement .
  7. Install the front tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and wheels.
  8. Lower the vehicle.
  9. Check the vehicle for alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.