Garage Door Opener Transmitter Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Garage Door Opener Transmitter Replacement
WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Garage Door Opener
GM1993567Courtesy of GENERAL MOTORS COMPANY
Garage Door Opener Transmitter Replacement

Callout Component Name
Preliminary Procedure 
Remove the roof console. Refer to Roof Console Replacement .
1 Garage Door Opener Bolt/Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2.5 N.m (22 lb in)
2 Garage Door Opener

Procedure

  1. Disconnect the electrical connections.
  2. Refer to Control Module References for programming and set up procedures.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.