Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1431 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)
2006 Pontiac G6 GTP, 2D Coupe, Standard
Section 1431 (Keyless Entry System And Remote Functions)
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Section 1431 (Keyless Entry System And Remote Functions)
WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- Repair Instructions
- Description and Operation
- Keyless Entry System Description and Operation
- Notes
- Keyless Entry Transmitters
- OnStar® Remote Link
- Remote Control Door Lock Receiver (RCDLR)
- Unlock Driver Door Only
- Unlock All Doors - Second Operation
- Lock All Doors
- Rear Compartment Lid Release
- Vehicle Locator/Panic Alarm
- Remote Vehicle Start (RVS), if equipped
- Enable/Disable RVS
- Hood Ajar Switch
- RVS Circuit Description
- Keyless Entry Personalization
- Rolling Code
- Automatic Synchronization
- Keyless Entry System Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.