Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1220 (FIXED AND MOVEABLE WINDOWS SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESPOWER WINDOWS MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2006 Pontiac G6 GTP, 2D Coupe, Standard
Circuit/System Verification
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, command the driver window UP and DOWN using the driver window switch. The driver window should perform the UP and DOWN functions.
- If the driver window does not perform the UP/DOWN function, refer to Driver Window Malfunction (Except RPO AXG) .
- Command each passenger window UP and DOWN using the window switches on the driver master control and the appropriate passenger door window switch. Each passenger window should perform the UP and DOWN functions from each switch.
- If the front passenger window does not perform the UP/DOWN function, refer to Front Passenger Window Malfunction .
- If either rear power windows do not perform the UP/DOWN function, refer to Rear Window Malfunction .
- Disable and enable the rear window door switches by pressing and depressing the lockout switch on the driver master control. The rear door power window switches should be enabled and disabled when changing between the commanded states.
- If both rear window switches continue to function while disabled, refer to Lockout Switch Malfunction .
- Except RPO AXG, command the express down function of the driver door window by pressing the driver window switch past the first detent and releasing. The driver window should perform the express down function.
- If the function does not perform as specified, replace the driver window switch.
- For RPO AXG, command the express up and express down function of the driver door window by pressing and pulling the driver window switch past the first detent and releasing. The driver window should perform the express up and express down function.
- If the function does not perform as specified, refer to Power Window Reinitialization .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.