SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM - 3.9L - INTRODUCTION (2 OF 2)REPAIR INSTRUCTIONSINTAKE MANIFOLD TUNING VALVE REPLACEMENTREMOVAL PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Removal Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Removal Procedure
    Fig 1: View Of Intake Manifold Tuning Valve Electrical Connector
    GM1582090Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the intake manifold tuning valve electrical connector (1).
  3. Remove the engine harness clip from the power steering reservoir bracket.
  4. Remove the power steering pump. Refer to Power Steering Pump Replacement
    5. Fig 2: Removing/Installing Intake Manifold Tuning Valve Bolts
    GM1557831Courtesy of GENERAL MOTORS CORP.
  5. Remove the intake manifold tuning valve bolts.
  6. Remove the intake manifold tuning valve.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.