Rear Side Door Window Regulator Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Rear Side Door Window Regulator Replacement
Fig 1: View Of Rear Side Door Window Regulator
GM1569784Courtesy of GENERAL MOTORS CORP.
Callouts For Fig 1

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:Β  Refer to Fastener Tightening SpecificationsΒ .

Preliminary Procedures

  1. Position the rear door window approximately half way down in the door.
  2. Remove the rear door trim panel. Refer to Trim Panel Replacement - Side Rear DoorΒ .
  3. Remove the rear door water deflector. Refer to Water Deflector Replacement - Rear DoorΒ .
  4. Remove the rear door window retaining pin. Refer to Window Regulator Replacement - Rear DoorΒ .
  5. Push the window to the full up position and tape it in place.
1 Bolt, Rear Door Window Regulator (Qty: 3)

Tighten:Β  10 N.m (89 lb in)

2 Regulator, Rear Door Window
Tip:Β  Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.