SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMREPAIR INSTRUCTIONSLOCK REPLACEMENT - FRONT DOOR (SEDAN)
2006 Pontiac G6 GTP, 2D Coupe, Standard

Lock Replacement - Front Door (Sedan)

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Lock Replacement - Front Door (Sedan)
Fig 1: View Of Front Side Door Lock
GM1576789Courtesy of GENERAL MOTORS CORP.
Callouts For Fig 1

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the interior trim panel. Refer to Trim Panel Replacement - Side Front Door (Driver)  or Trim Panel Replacement - Side Front Door (Passenger) .
  2. Remove the water deflector. Refer to Water Deflector Replacement - Front Door (Coupe and Convertible)  or Water Deflector Replacement - Front Door (Sedan) .
  3. Remove the outside door handle. Refer to Door Handle Replacement - Front Outside .
1 Screw, Front Side Door Lock (Qty: 3)

Tighten:  10 N.m (89 lb in)
2 Screw, Door Handle Housing

Tighten:  10 N.m (89 lb in)
3 Lock Assembly, Front Side Door
Tip: 
  1. Release the door lock cable retainers from the door.
  2. Disconnect the door lock electrical connector.
  3. Remove the door lock with the handle housing.
  4. Remove the handle and lock rods from the lock.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.