Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMREPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REGULATOR REPLACEMENT (SEDAN)

2006 Pontiac G6 GTP, 2D Coupe, Standard

Front Side Door Window Regulator Replacement (Sedan)

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Front Side Door Window Regulator Replacement (Sedan)

Fig 1: View Of Front Side Door Window Regulator Replacement

Courtesy of GENERAL MOTORS CORP.

Callouts For Fig 1

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Position window approximately half way down in the door. Remove the interior trim panel. Refer to Trim Panel Replacement - Side Front Door (Driver) or Trim Panel Replacement - Side Front Door (Passenger) . Remove the water deflector. Refer to Water Deflector Replacement - Front Door (Coupe and Convertible) or Water Deflector Replacement - Front Door (Sedan) .
1	Bolt, Front Side Door Window to Regulator (Qty: 2) Tip: Loosen the window to regulator bolts. Push the window to the full up position and tape in place. Tighten: 10 N.m (89 lb in)
2	Bolt, Front Door Window Regulator (Qty: 4) Tip: Disconnect window regulator electrical connector. Tighten: 10 N.m (89 lb in)
3	Regulator, Front Door Window

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.