SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994SUNDANCE BASE, 2D HATCHBACK, 2.2 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 9 (TRAVELER MODULE)DIAGNOSTIC CHARTSTEST VER-1 - VERIFICATION PROCEDURE
1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, Automatic

Test VER-1 - Verification Procedure

1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, AutomaticSECTION Test VER-1 - Verification Procedure
WARNING: This page is about a different car, the 1994 Plymouth Acclaim, 1994 Dodge Spirit, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS. After each repair, perform TEST VER-1.

Reconnect all components and connectors that were disconnected for testing. Verify all repairs have been made. Turn ignition switch to OFF position, then back to ON position. Using DRB, clear all trouble codes and actuate system which was not operational. If system operates properly, repair is complete. If system is still malfunctioning, go to TEST 1A.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.