Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994SUNDANCE BASE, 2D HATCHBACK, 2.2 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 9 (TRAVELER MODULE)DIAGNOSTIC CHARTSTEST 2D - REPAIRING DAY BRIGHTNESS CIRCUIT TO TRAVELER
1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, Automatic
Test 2D - Repairing Day Brightness Circuit To Traveler
1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, AutomaticSECTION Test 2D - Repairing Day Brightness Circuit To Traveler
WARNING: This page is about a different car, the 1994 Plymouth Acclaim, 1994 Dodge Spirit, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION table. For wiring diagram, see WIRING DIAGRAMS. After each repair, perform TEST VER-1.
- Turn ignition switch to OFF position. Turn headlights off. Access headlight switch connectors. DO NOT disconnect connectors. Using DRB in ohmmeter mode, backprobe headlight switch 2-pin connector terminal No. 2 (Yellow/Black wire). If resistance is more than 5 ohms, go to step 4). If resistance is less than 5 ohms, go to next step.
- Disconnect headlight switch 2-pin connector. Check resistance of headlight switch 2-pin connector (Yellow/Black wire). If resistance is more than 5 ohms, replace headlight switch. If resistance is less than 5 ohms, go to next step.
- Turn ignition switch to OFF position. Disconnect traveler module 7-pin connector. See Figure . Check resistance of headlight switch 2-pin connector terminal No. 2 (Yellow/Black wire). If resistance is more than 5 ohms, replace traveler module. If resistance is less than 5 ohms, repair short to ground in Yellow/Black wire.
- Disconnect headlight switch 2-pin connector. Connect a jumper wire between headlight switch 2-pin connector terminal No. 2 (Yellow/Black wire) and headlight switch 9-pin connector terminal B2 (Pink/Red wire). If DRB displays CIRCUIT CLOSED, replace headlight switch. If DRB does not display CIRCUIT CLOSED, go to next step.
- Leave jumper wire connected. Disconnect traveler module 7-pin connector. See Figure . Using DRB in voltmeter mode, check voltage on traveler module 7-pin connector terminal No. 4 (Yellow/Black wire). If voltage is less than 10 volts, repair open Yellow/Black wire. If voltage is more than 10 volts, replace traveler module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.