Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994SUNDANCE BASE, 2D HATCHBACK, 2.2 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 20 (AIR BAG RESTRAINT SYSTEM)DIAGNOSIS & TESTINGENTERING ON-BOARD DIAGNOSTICSNOTES
1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, Automatic
Entering On-Board Diagnostics: Notes
1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, AutomaticSECTION Notes
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Before entering on-board diagnostics, refer to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE. Turn ignition off. Attach most current DRB cartridge. Beginning in 1991, DRB cartridge has ability to check itself and DRB. It provides a volt-ohmmeter and performs any test required by air bag system diagnostics.
- Connect DRB to ACM data link connector. ACM data link connector (also known as DRB connector) is located at lower right of steering column. Ensure all accessories are off. Turn ignition on. All character positions will glow and copyright information will appear on screen for a few seconds. Display will then change to DRB menu.
- If DRB displays error message, see DRB ERROR MESSAGES. Following modes are accessible from DRB menu: VEHICLES TESTED, HOW TO USE, CONFIGURE and SELECT SYSTEM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.