Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection (Fuel Pump Control Module)
2024 Nissan-Datsun Frontier SL, RWDSECTION Component Inspection (Fuel Pump Control Module)
- CHECK FUEL PUMP CONTROL MODULE
Check the voltage between fuel pump control module terminals under the following conditions.
Fuel pump control module Condition Voltage (Approx.) Connector + - Terminal C2 6 5 For 1 second after turning ignition switch ON 12.9 V More than 1 second after turning ignition switch ON 0 V Idle speed 8.1 - 12.9 V Is the inspection result normal?
>>
INSPECTION END
>>
Replace fuel pump control module. Refer to Removal and Installation .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.