SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (DTC/CIRCUIT DIAGNOSIS) (1 OF 6)DTC/CIRCUIT DIAGNOSISDTC P0011: INTAKE VALVE TIMING CONTROLDIAGNOSIS PROCEDURE
2024 Nissan-Datsun Frontier SL, RWD

Diagnosis Procedure

2024 Nissan-Datsun Frontier SL, RWDSECTION Diagnosis Procedure

TYPE A 

  1. CHECK ELECTRIC IVT CONTROL ACTUATOR (BANK 1) MOTOR CONTROL CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect electric IVT control actuator (bank 1) harness connector and electric IVT control module harness connector.
    3. Check the continuity between electric IVT control actuator (bank 1) harness connector and electric IVT control module harness connector.
      Electric IVT control actuator (bank 1) Electric IVT control module Continuity
      Connector Terminal Connector Terminal
      F112 1 F105 40 Existed
      2 37
      3 42
    4. Check harness for short to power and short to ground.

    Is the inspection result normal?

    >>

    Replace electric IVT control actuator (bank 1). Refer to Removal and Installation .

    >>

    Repair or replace error-detected parts.

TYPE B 

  1. CHECK TIMING CHAIN INSTALLATION 

    Check service records for any recent repairs that may cause timing chain misaligned.

    Are there any service records that may cause timing chain misaligned?

    >>

    Check timing chain installation. Refer to Removal and Installation .

    >>

    GO TO 2.

  2. CHECK CAMSHAFT SPROCKET AND TIMING CHAIN 

    Check the following.

    1. Visually check for chipping camshaft sprocket (bank 1) gear tooth.
    2. timing chain tension and elongation.

    Is the inspection result normal?

    >>

    INSPECTION END

    >>

    Repair or replace error-detected parts.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.