Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
CONSULT Function (SIDE RADAR RIGHT)
DESCRIPTION
CONSULT performs the following functions by communicating with the side radar RH.
| Select diag mode | Function |
|---|---|
| Self Diagnostic Result | Displays memorized DTC in the side radar. |
| Data Monitor | Displays real-time data of side radar. |
| Active Test | Enables operation check of electrical loads by sending driving signal to them. |
| ECU Identification | Displays part number of side radar. |
SELF DIAGNOSTIC RESULT
Self Diagnostic Result
Displays memorized DTC in side radar RH. Refer to DTC Index .
FFD (Freeze Frame Data)
The side radar records the following data when the malfunction is detected.
| Freeze Frame Data item | Description |
|---|---|
| TURN SIG STATUS | Turn signal status at the moment a malfunction is detected is displayed |
DATA MONITOR
| Monitored item [Unit] | Description |
|---|---|
| BSW/CTA WARN STATUS [On/Off] | Indicates [ON/OFF] status of vehicle detection |
| CTA SYSTEM ON [On/Off] | Indicates [ON/OFF] status of Rear Cross Traffic Alert system |
| BSW STATUS [On/Off] | Indicates [ON/OFF] status of Blind Spot Warning system |
| VHCL SPD SE [km/h] | Indicates vehicle speed [km/h] |
| TURN SIGNAL [LH/RH/Off] | Indicates the [LH/RH/OFF] operation of the signal |
| SHIFT POSITION [P/R/N/D] | Indicates position of transmission range switch |
| LUMINANCE (LEFT) [Hi/Lo] | Indicates the left side luminance level of the radar |
| LUMINANCE (RIGHT) [Hi/Lo] | Indicates the right side luminance level of the radar |
ACTIVE TEST
- Never perform the active test while driving.
- Active test cannot be started while the Blind Spot Warning indicator is illuminated.
| Active test item | Operation | Description |
|---|---|---|
| BSW/BSI INDICATOR DRIVE | On | Outputs the voltage to illuminate the Blind Spot Warning indicator. |
| Off | Stops the voltage to illuminate the Blind Spot Warning indicator. |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.